سفارش تبلیغ
صبا ویژن

مقاله Undesirable Sudden Curing of Epoxy/Clay Nanoدرcomposites i

 

برای دریافت پروژه اینجا کلیک کنید

مقاله Undesirable Sudden Curing of Epoxy/Clay Nanoدرcomposites in VARTM Manufacturing Process تحت pdf دارای 6 صفحه می باشد و دارای تنظیمات در microsoft word می باشد و آماده پرینت یا چاپ است

فایل ورد مقاله Undesirable Sudden Curing of Epoxy/Clay Nanoدرcomposites in VARTM Manufacturing Process تحت pdf کاملا فرمت بندی و تنظیم شده در استاندارد دانشگاه و مراکز دولتی می باشد.

این پروژه توسط مرکز مرکز پروژه های دانشجویی آماده و تنظیم شده است

توجه : در صورت  مشاهده  بهم ریختگی احتمالی در متون زیر ،دلیل ان کپی کردن این مطالب از داخل فایل ورد می باشد و در فایل اصلی مقاله Undesirable Sudden Curing of Epoxy/Clay Nanoدرcomposites in VARTM Manufacturing Process تحت pdf ،به هیچ وجه بهم ریختگی وجود ندارد


بخشی از متن مقاله Undesirable Sudden Curing of Epoxy/Clay Nanoدرcomposites in VARTM Manufacturing Process تحت pdf :

سال انتشار: 1389

محل انتشار: دومین کنفرانس بین المللی کامپوزیت

تعداد صفحات: 6

نویسنده(ها):

M. H. Pol – PhD student, Institute of Manufacturing Technology Research, ACECR, Ahvaz, Iran
F Hajiarazy – MSCStudent, Mechanical Engineering Department, Tarbiat Modares University
S.M.H Seyedkashi – PhD student, Institute of Manufacturing Technology Research
Gh Liaghat – Professor, Tarbiat Modares University

چکیده:

In this study, dependence of undesirable sudden curing of epoxy/organoclay nano-composites on mixing duration and moreover the effect of nanoclay on molding process in VARTM manufacturing process are investigated. Nanoclay was dispersed into resin in a 1%, 3% and 5% wt with ultrasonic. The final mixing duration of all suspensions was 5 and 15 minutes with speed of 1000 RPM. X-ray diffraction (XRD) tests indicate that these nanostructures are mostly in intercalated form. By increasing the nanoclay percentage, the rate of increase of viscosity increased and this caused the increase in molding time. The pressure drop at the inlet of vacuum pipe along with the increase of d-spacing of nanoclay in VARTM process (caused by the increase of mixing duration) lead to this phenomenon. In this paper this phenomenon is discussed.

 

 

برای دریافت پروژه اینجا کلیک کنید

کلمات کلیدی :