پایان نامه

 

مقاله Numerical Simulation of Temperature Distribution in the Workpiece due to Electrical Discharge Machining (EDM), Using Hyperbolic Heat Conduction Model تحت pdf دارای 12 صفحه می باشد و دارای تنظیمات در microsoft word می باشد و آماده پرینت یا چاپ است

فایل ورد مقاله Numerical Simulation of Temperature Distribution in the Workpiece due to Electrical Discharge Machining (EDM), Using Hyperbolic Heat Conduction Model تحت pdf کاملا فرمت بندی و تنظیم شده در استاندارد دانشگاه و مراکز دولتی می باشد.

این پروژه توسط مرکز مرکز پروژه های دانشجویی آماده و تنظیم شده است

توجه : در صورت  مشاهده  بهم ریختگی احتمالی در متون زیر ،دلیل ان کپی کردن این مطالب از داخل فایل ورد می باشد و در فایل اصلی مقاله Numerical Simulation of Temperature Distribution in the Workpiece due to Electrical Discharge Machining (EDM), Using Hyperbolic Heat Conduction Model تحت pdf ،به هیچ وجه بهم ریختگی وجود ندارد

---

بخشی از متن مقاله Numerical Simulation of Temperature Distribution in the Workpiece due to Electrical Discharge Machining (EDM), Using Hyperbolic Heat Conduction Model تحت pdf :

سال انتشار: 1389

محل انتشار: یازدهمین کنفرانس ملی مهندسی ساخت و تولید ایران

تعداد صفحات: 12

نویسنده(ها):

Seyfolah Saedodin – Assistant Professor, Department of Mechanical Engineering, Faculty of Engineering, Semnan University
Mohsen Torabi – M.S., Department of Mechanical Engineering, Faculty of Engineering, Semnan University,
Hadi Eskandar – M.S., Department of Mechanical Engineering, Faculty of Engineering, Semnan University
Pouya Salehi – M.S., Department of Mechanical Engineering, Faculty of Engineering, Semnan University

چکیده:

Determination of temperature distribution is reported in the workpiece due to EDM using non-Fourier heat conduction model. The governing equations are expressed in cylindrical coordinates. Equations are solved by deriving the numerical solution. The temperature layers and the profiles of sample calculations show that, it is not acceptable to apply the Fourier heat conduction model for estimating the temperature of workpiece. On the other hand, it can be seen that the numerical solution is in good agreement with the analytical solution that has been presented in the published papers.

 

 

کلمات کلیدی :